Maytag refrigerator not freezing. The refrigerator is one of those things that are essential to running a modern home. It keeps food fresh and your drinks cold. What should you do?
However, sometimes your fridge doesn’t work. Sometimes it runs slowly. Sometimes it won’t even keep ice cold.
If you’re wondering what to do when your new Maytag refrigerator isn’t cooling or freezing, this article will walk you through the best ways to fix this problem.
Maytag Refrigerator Not Freezing
There are many reasons why your refrigerator may fail to cool. As a general rule, if your refrigerator doesn’t cool, it’s usually because of the following:
- Too little water.
- Insufficient ventilation.
- Faulty compressor.
- Overloading the compressor.
1. Turn off the refrigerator, then turn it back on
It’s no secret that the fridge runs on electricity. You essentially depend on a power supply when you turn it on.
If there’s a problem with the electricity going to the fridge, it could cause the refrigerator not to work.
The first step is to turn off the fridge to fix this problem. To do this, turn off the power cord to the refrigerator.
After all this, your fridge should be working again. It might be necessary to replace the power supply if it is still not.
2. Check for leaks
Leaking air in your refrigerator can cause your food to spoil and even burn your food. Before you start to clean your fridge, first make sure that you’ve checked for any leaks. To check for leaks, follow these steps:
- Unplug your refrigerator.
- Turn off the gas valve if you have one.
- Open up your refrigerator, and look at the inside.
- If you notice cracks or leaks, you need to get them fixed.
- If you have a water dispenser, make sure that you empty it before turning on your refrigerator.
3. Replace the evaporator fan (or filter)
When the refrigerant is compressed, it gets hot and expands. The compressor uses a motor, and the motor needs lubrication.
This is why most compressors include an evaporator fan. It blows air over the motor and keeps it from overheating.
When the evaporating fan stops working, the whole refrigerator stops working. So, if your refrigerator isn’t cooling, it’s time to replace the evaporator fan.
4. Make sure the door is closed properly
In many cases, a cracked door can cause problems with the temperature control system. Ensure the door is closed, and check to see if the door gasket is still installed correctly. If the gasket isn’t installed correctly, the door may not close properly
5. Check the temperature control settings
If you’ve checked the manual and the temperature control settings are correct, you may consider contacting the manufacturer.
It’s important to remember that the most important factor is the outside temperature when you’re setting the temperature.
The outside temperature is the temperature your thermostat is set to, and it will determine the inside temperature.
If the outside temperature is below 10 degrees Fahrenheit, your thermostat is likely to set to turn the heat on.
As a result, the inside temperature will likely stay at about 72 degrees, even if the outside temperature is around 0 degrees.
If this is the case, then you have two options:
- Adjust your thermostat to turn the heat on at a lower temperature. This will increase the temperature difference between the inside and outside your house.
- Change your refrigerator to an upright model, which is more energy-efficient. It can also be easier to clean.
6. Check the compressor and thermostat
Another common problem is that the compressor isn’t cooling enough. Make sure the compressor is in good shape and has enough air flowing through it.
Check the thermostat. In most cases, a malfunctioning thermostat will prevent the door from closing, so make sure that the thermostat is working correctly.
7. Clean the refrigerator’s door seals
If the door seal is not installed correctly, the refrigerator will not be able to maintain a good seal. This means that food and liquids will be able to leak out of the door.
A leaky door can lead to water damage in the refrigerator. This could mean mold growth in your refrigerator. You should always check the seal on your refrigerator’s door. If it is not installed correctly, you should have it fixed immediately.
Maytag refrigerator not freezing. A refrigerator that doesn’t cool or freezes properly is a common problem for many people. If your fridge isn’t cooling or freezing properly, you may need to replace the compressor or the evaporator fan.
The compressor is located near the bottom of the fridge, while the evaporator fan is located near the top.
If the compressor or fan isn’t working right, you should call a repairer. Cleaning the fan or replacing the air filter are two things you can do yourself.